Broadcast Tools ProMix 12 Spezifikationen PDF herunterladen (Seite 3)

ee--mmaaiill::

[email protected]

vvooiiccee::

360.854.9559

ffaaxx::

866.783.1742

ProMix 12 Installation and Operation Manual

DESCRIPTION

1.0 DESCRIPTION

The ProMix 12 is a full-featured audio mixing console ideally suited for the typical

broadcast studio or any similar application. It features inputs for 3 microphones and

9 stereo line sources, two stereo mixing buses, a “mix-minus” output, a mono out-

put, and comprehensive cue and monitoring systems. Other functions include an

announce booth output with full duplex talkback, accurate audio level metering,

remote control of Microphone channels and remote-start facilities on all line input

channels.

2.0 INSTALLATION

(See Figure 1 for connectors and controls (x) referenced in the text.)

2.1 AUDIO CONNECTIONS

2.1.1 MICROPHONE INPUTS

The ProMix 12 has inputs for up to 3 microphones. Microphones should be low-

impedance professional units with balanced outputs. Dynamic microphones are

suggested. Powered condenser s can be used, although the console does not provide

phantom power. Connect microphones to the female XLR connectors (1) on the rear

of the console. The microphone plug should be wired as follows:

PIN 1: Ground

PIN 2: Hi

PIN 3: Lo.

2.1.2 MICROPHONE PROCESS INSERT

The ProMix 12 provides for the insertion of external processing equipment, e.g, a

microphone limiter or equalizer. External microphone processing equipment should

be interfaced via the T/R/S microphone process Insert jacks (2). These jacks pro-

vide a means of inserting processing gear just after the console’s microphone pre-

amps, but before the microphone channel faders. The microphone preamp output

and return circuits are unbalanced, at a nominal level of –10dbm. Wire the mating

T/R/S plug as follows:

TIP: To processor input (from microphone preamp output)

RING: From processor output (to console fader input)

SLEEVE: Ground.

NOTE: For the “R0, RA and RB” version of the console, internal shunt

(jumper JP1 (Mic-1), JP2 (Mic-2) or JP3 (Mic-3) must be removed on the I/O

circuit assembly (the bottom cover must be removed to access these jumpers).

WEBSITE:

Visit our web site for

product updates and

additional information.

1 2 3 4 5 6 7 8 ... 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare

Broadcast Tools ProMix 12 Spezifikationen Seite 3

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Audiomischer Broadcast Tools ProMix 12