Broadcast Tools DSC-20 Installationshandbuch PDF herunterladen (Seite 14)

Preliminary 8-2002 RSHD Smartcaster Installation Manual

CON2 is the interface for the satellite closure inputs. It runs from CON2 of the

Smartcaster to the small blue terminal board.

Notice that the method of constructing the cable involves trapping the flat wire in a

connector. After the connector is crimped, the excess wire is trimmed, a inspection of the

raw end of this cable may show some excess wire still there, if the edge of that wire

comes in contact with the case of the computers, false closures can appear, or a short will

re-boot the computer. Always check for clearance at the connection to the computer.

Audio into and out of Computer

Included with your package are four gold 1/8” mini plug audio cables, these are not cut

down to length. You will remove the RCA plugs from one end of three of the four cables

and discard them.

(Photo)

1/8 mini plugs wired to the green connector

Pin 1- Left +

Pin 2- Shield / Ground

Pin 3- Shield / Ground

Pin 4-Right +

Pin 5- Shield / Ground

One of these cables will run from the REC(ord) out of the RIDZ to the record input of the

RSHD record / audition audio card. There are two cables from the AIR card outputs to

the Channel 9 input on the RIDZ.

The fourth audio cable is run from the audition output jack of the RSHD box to your

audio console for cue return audio. This cable is unbalanced audio, and the only

interconnection to you equipment that is so. You may add one of a number of brands of

converters to bring this up to fully level balanced audio. That is recommended,

especially on older consoles that need the extra output level.

One such device is from Radio Design Labs. The STA-1.

Figure 6 STA-1 Level matching device

E-Mail: RDL American/Asian Sales: (800) 281-2683, (805) 684-5415, Fax: (800) 289-

7338, (805) 684-9316

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 56 57

Keine Kommentare

Broadcast Tools DSC-20 Installationshandbuch Seite 14