Broadcast Tools DSC-20 Installationshandbuch PDF herunterladen (Seite 19)

Preliminary 8-2002 RSHD Smartcaster Installation Manual

one of two directions. The switcher may send the audio source to the air, or to the record

bus.

Wiring the RIDZ

A wire stripper and a standard blade screwdriver are needed to wire the female screw

plugs. These screw plugs can accommodate 14 to 22 AWG wire. The lighter gauge

stranded wire (22 AWG) is preferred because it is more flexible and easier to use. Strip

back the insulation on the wires about 1/4". The audio input connections can be wired as

balanced inputs or as unbalanced inputs. It is CRITICAL that they be wired correctly. If

they are wired incorrectly there may be problems with phase reversal or other related

audio problems.

Figure 7-Connections

RIDZ balanced audio connections, both input and output

Pin 1- Left Hot +

Pin 2- Left Cold -

Pin 3-Shield / Ground

Pin 4-Right Hot +

Pin 5-Right Cold –

RIDZ un-balanced audio connections, input

Pin 1- Left +

Pin 2- Shield / Ground

Pin 3- Shield / Ground

Pin 4-Right +

Pin 5- Shield / Ground

General Information for the RIDZ (8 x 2) Switcher:

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 56 57

Keine Kommentare

Broadcast Tools DSC-20 Installationshandbuch Seite 19