Broadcast Tools SS 16.4 Spezifikationen PDF herunterladen (Seite 14)

e-mail:

[email protected]

voice:

360.854.9559

fax:

866.783.1742

SS 16.4 Installation and Operation Manual

INSTALLATION

Serial Control:

The unit is controlled in either Menu or Burst mode. It can run at the following

data rates:

• 2400

• 9600 Default

• 19,200

• 38,400

Serial communications is either multi-drop RS-232 or RS-485, jumper selectable.

Commands may be entered either via a menu (menu mode) or a short form code

(burst mode). All commands and responses use normal ASCII characters, facilitat-

ing scripting. A burst mode command starts with an asterisk (“*”) followed by the

device (ID) address as a single decimal digit. A burst mode command must be

entered within 5 seconds or it will time out. The command to enter menu mode

starts with an asterisk (“*”) followed by the device (ID) address as a single decimal

digit and then MM. The menu mode displays certain parameters, and allows the

setting of these parameters. In both cases, device (ID) address (0-3) is specified

with the on-board dipswitches.

Type *0MM, follow the prompts on the pop-up menu.

Menu Mode:

The command to enter menu mode starts with an asterisk (“*”) followed by the

device (ID) address as a single decimal digit, then the MM command. NOTE:

Commands you type will NOT be seen, unless you turn “Echo On” in

HyperTerminal. The menu mode displays advanced configuration parameters.

Unit ID, Baud rate and other configurations are set via the on-board dipswitches

(SW24) at the rear of the unit.

Broadcast Tools® SS 16.4, v1.xx - Setup Menu

1 - Set PIP Minimum (0 - 2.55 sec) - Now: 1.00

2 - Set Remote Mode Open Collector Mode - Now: "Follow"

3 - Set Silence Sense Acquire Delay (sec) - Now: 10

4 - Set Silence Sense Restore Delay (sec) - Now: 10

A - Save Current Audio State for Power Up

C - Show Current Configuration

F - Set Factory Defaults

Enter Selection, or Q to quit.

WEBSITE:

Visit our web site for

product updates and

additional information

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20 21

Kommentare zu diesen Handbüchern

Keine Kommentare

Broadcast Tools SS 16.4 Spezifikationen Seite 14

Kommentare zu diesen Handbüchern