Broadcast Tools WVRC-8 Spezifikationen PDF herunterladen (Seite 14)

e-mail:

voice:

360.854.9559

fax:

866.783.1742

WVRC-8 Installation and Operation Manual

PROGRAMMING

Local “DIAL-UP” programming via the front/rear panel RS-232 “PGM”

port.

1 - Connect the supplied straight-through serial cable to an available com port on your PC

(If the PC isn’t equipped with a serial (com) port, contact your local PC store or

Broadcast Tools for a USB to RS-232 serial adapter) and connect the other end to the

front or rear panel “PGM” DB-9 female serial connector.

2 - Start HyperTerminal (or your favorite com program) configured for: 9600,8,N, 1, flow

control to NONE, Emulation set to ANSI and under ASCII setup, check the box

“echo typed characters locally”.

NOTE: Step by step “COM” port HyperTerminal setup instructions are available on-

line at

www.broadcasttools.com under “Downloads”.

3 - Press the front panel “PGM” button. The front panel “PGM” LED will illuminate,

while the program menu on the next page will be displayed:

Dial Out Numbers:

When (1) is selected from the PGM Menu, the Dial-Out number list will be displayed.

These are the numbers that will be dialed when alarms are generated. The

dial-out list will select numbers from this pool to call out during an alarm condition. Up

to 32 digits can be used in each number along with a comma (,) for one second and a

semi-colon (;) for 5 second pauses.

Example: The first dial out number is 8549559. This number will be dialed when a 1 is

inserted in any of the dial list items.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 40 41

Keine Kommentare

Broadcast Tools WVRC-8 Spezifikationen Seite 14