Broadcast Tools WVRC-8 Spezifikationen PDF herunterladen (Seite 20)

e-mail:

voice:

360.854.9559

fax:

866.783.1742

WVRC-8 Installation and Operation Manual

PROGRAMMING

Recording Voice Messages

The following steps are required to record voice messages into the WVRC-8.

NOTE: If the time allotted for the message you are recording elapses before the

“PGM” button is pressed, it will turn off automatically.

Example: To record the greeting message, press the “PGM” button, enter 00 on the key-

pad, speak the new greeting message, then press the “PGM” button again.

1 - Connect a TT telephone to either the front or rear panel RJ-11 jacks labeled “PGM”.

2 - Press the front panel “PGM” button; this should illuminate the front panel “PGM” led.

3 - Enter the two-digit address of the message you wish to program. The list of messages

are below.

4 - The red “REC” led will illuminate. As soon as it lights, begin speaking the new mes-

sage into the telephones mouth piece.

5 - When finished, press the PGM button again, the “REC” and the “PGM” led’s will

extinguish.

NOTE: The following above procedures allows changing any of the messages.

If you want to listen to a message, without recording, preface the address with

the asterisk (*) key.

Example: To hear the current greeting message, press the “PGM” button and

Enter *00. The current greeting message will play. Here is a list of the voice

messages pre-recorded in the WVRC-8.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 40 41

Keine Kommentare

Broadcast Tools WVRC-8 Spezifikationen Seite 20